May 9, 2025
Whirlpool Dryer LEC5000PQ1 Not Heating? Here’s How to Fix It Fast
If your Whirlpool electric dryer model LEC5000PQ1 is running but no longer producing heat, you're not alone. This is one of the most common problems with this model—and the good news is, there’s a reliable fix.
This issue is typically caused by one or more failed components in the heating circuit. In most cases, the problem can be resolved by replacing the heating element, thermal fuse, and cycling thermostat—all of which are included in a single, easy-to-install repair kit.
Common Symptoms
- Dryer turns on and tumbles, but produces no heat
- Clothes come out cold or damp after the cycle ends
- Dryer seems to run longer than normal without drying clothes
Most Likely Cause: Failed Heating Components
The LEC5000PQ1 model uses an electric heating element to generate heat. Over time, that element can burn out or be damaged by overheating. Additionally, the thermal fuse or cycling thermostat can fail, cutting off power to the heating circuit.
Rather than replacing just one part and hoping it solves the problem, it’s best to install a complete kit that includes all three of the most common failure points.
Get the Right Repair Kit
We’ve made it easy by offering a full Whirlpool LEC5000PQ1 Heating Element Repair Kit that includes the heating element, thermal fuse, and cycling thermostat—everything you need to get your dryer working again.
Click here to order the repair kit for Whirlpool LEC5000PQ1
How to Install the Heating Element Repair Kit
Step 1: Unplug the Dryer
Always disconnect your dryer from the electrical outlet before performing any repairs.
Step 2: Access the Back Panel
Use a 1/4" nut driver to remove the screws holding the back panel in place. Lift off the panel to access the heating element housing.
Step 3: Locate and Remove Faulty Parts
- Heating Element: Mounted in a metal housing near the lower back side.
- Thermal Fuse: Usually attached to or near the blower housing.
- Cycling Thermostat: Mounted on or near the heating element housing.
Disconnect the wires and remove the mounting screws for each component. Replace them one by one with the new parts from the kit.
Step 4: Reassemble and Test
Once all components are installed, reattach the back panel, plug the dryer back in, and run a short drying cycle. If everything was installed correctly, your dryer should now be heating as expected.
Pro Tip: Keep It Clean
Clogged vents and lint buildup can cause overheating, which leads to part failure. After the repair, take time to clean your dryer’s lint trap, internal ducts, and exterior venting to extend the life of your replacement parts.
If you’re still having issues after replacing the kit, it could be a wiring or control board issue. But for most users, this fix gets the LEC5000PQ1 heating again in under an hour.
