Washer Not Filling With Water

If your washer isn't filling with water even though the water supply valves are turned on, here are the most common issues to check:

• Clogged Inlet Screens: The screens inside the fill hoses or water valve ports may be clogged with debris. Turn off the water, disconnect the hoses, and inspect both ends for blockages.
• Faulty Water Inlet Valve: The solenoid-controlled valve may have failed. If it's not opening when energized, it needs to be replaced.
• Failed Water Level Sensor: If the pressure switch or sensor thinks the tub is already full, it won't allow more water in. This can prevent filling even when it's actually empty.
• Control Board or Timer Issues: If all mechanical parts are good, the washer’s control system may not be sending the signal to fill. This usually requires further electrical testing.

Start by checking the inlet screens and hoses. If those are clear, the inlet valve is the next most common failure point and is relatively easy to replace. If you need a part number for the water inlet valve, just submit a follow up question with your washer model number requesting the part number for the water valve and we will be glad to give you that information.